Instructions / Assembly

1) Score and remove 1” of

outer jacket. Do not nick

inner conductors with blade.

4) Untwist top portion of

wires, align conductors in

568A or 568B order, and use

scissors to trim to ¼”

minimum (

3/8” maximum).

3) Place sled over

twisted pairs. Place

pairs based on 568A or

568B order.

5) Place liner over

trimmed

conductors. Wire

tips should touch

closed end of liner.

6) Slide assembly

into plug body,

ensuring

conductors are

fully inserted to

the end of the

body.

8) Verify correct

wiring and

termination with a

wiremap tester.

CAT6 Modular Plug Termination Instructions

2) Remove center spline

as close to jacket end as

possible.

7) Terminate the plug

with a modular plug

crimper. Use the RJ45

8-position 8-contact

cavity.

PAGE 1
CAT6 Modular Plug Termination Instructions 1) Score and remove 1” of outer jacket. Do not nick inner conductors with blade. 5) Place liner over trimmed conductors. Wire tips should touch closed end of liner. 2) Remove center spline as close to jacket end as possible. 6) Slide assembly into plug body, ensuring conductors are fully inserted to the end of the body. 3) Place sled over twisted pairs. Place pairs based on 568A or 568B order. 7) Terminate the plug with a modular plug crimper.
PAGE 2
CAT6 Modular Plug Termination Instructions Assembly Tips: When assembling the IDEAL 85-366 CAT6 modular plugs keep these tips in mind. • • • • • • • • • Place the twisted pairs in the sled according to 568A or 568B scheme chosen. The brown pair should always be in one of the rounded holes. The blue pair should always be in the middle (recessed) section. The location for the orange and green pairs will depend on A or B. configuration chosen.