Installation Guide

1) Use coax stripper to strip

cable so ¼” of conductor

and ¼” of braiding are

exposed. (45-605 shown)

3) Center cable over back end of

connector and push connector

on to cable until fully seated.

2) Fold back braiding, make sure

no braids are touching the

center conductor. Straighten

conductor if needed. Do not

remove foil that is attached to

the white dielectric (RG6/6Q)

4) Cable is fully seated when

braiding is visible in the clear

InSITE® window.

5) Place assembly in compression

tool (30-793 shown) and

compress.

6) Verify connector is fully

compressed. Clear window should

no longer be visible.

IDEAL BNC Compression Termination Instructions

RG59 coax is used in this example. General preparation instructions are the same for all IDEAL BNC compression

connectors. When working with RG6 Quad cable, the outer foil can be removed, and the inner braiding should be

folded down. This makes it easier to push the connector on to the cable.