SDS

Material Safety Data Sheet
Report No.:STR14109087S Page 8 of 10
Shenzhen SEM.Test Technology Co., Ltd.
1/F, Building A, Hongwei Industrial Park, Liuxian 2nd
Road, Bao'an District, Shenzhen, P.R.C. (518101)
Section 12 - Ecological Information
General note: Water hazard class 1(Self-assessment): slightly
hazardous for water.
Do not allow undiluted product or large quantities
of it to reach ground water, water course or
sewage system.
Anticipated behavior of a chemical product in
environment/possible environmental
impace/ecotoxicity
Not Available
Mobility in soil Not Available
Persistence and Degradability Not Available
Bioaccumulation potential Not Available
Other Adverse Effects Not Available
Section 13 – Disposal Considerations
Product disposal recommendation: Observe local, state and federal laws and regulations.
Packaging disposal recommendation: Be aware discarded batteries may cause fire, tape the battery
terminals to insulate them. Don’t disassembly the battery. Completely discharge containers (no tear
drops, no powder rest, scraped carefully). Containers may be recycled or re-used. Observe local,
state and federal laws and regulations.
The potential effects on the environment and human health of the substances used in batteries and
accumulators; the desirability of not disposing of waste batteries and accumulators as unsorted
municipal waste and of participating in their separate collection so as to facilitate treatment and
recycling;
Section 14 – Transport Information
This report applies to by sea, by air and by land;
Alkaline Battery complies with SP A123 the UN Recommendations on the Transport of
Dangerous Goods; IATA Dangerous Goods regulations, and applicable U.S. DOT regulations for the
safe transport of Alkaline Battery.
The Alkaline Battery according to SP 123 of the 2013 IATA Dangerous Goods regulations 54
th
Edition may be transported. and applicable U.S. DOT regulations for the safe transport of Alkaline
Battery.
The packaging shall be adequate to avoid mechanical damage during transport, handling and
stacking. The materials and pack design shall be chosen so as to prevent the development of