Instruction Manual

3
● Prevent metal fragments or wire chips from dropping inside the Touch housing. Ingress
of such fragments and chips may cause fire hazard, damage, and malfunction.
● Use a power supply of the rated value. Using a wrong power supply may cause fire
hazard.
● The Touch uses “PS2 of EN61131” as DC power supply. (based on the IEC/EN61131
rating)
● Use wire of a proper size to meet the voltage and current requirements.
● When exporting the Touch to Europe, use an EN60127 ( EC60127) approved fuse on
the power line outside the Touch.
● When exporting the Touch to Europe, use an EU-approved circuit protector.
● Make sure of safety before starting and stopping the Touch. Incorrect operation of the
Touch may cause mechanical damage or accidents.
● Use the Touch in a local area network if you download, upload or monitor the project
data via the Ethernet port.
● The touch panel of the Touch is made of glass, and will break if exposed to excessive
shock. Take due care when handling it.
● When more than one button is pressed at the same time, due to the detection
characteristics of an analog type touch panel, only the gravity center of the pressed area
is sensed and the unit assumes that only one button is pressed. Thus, when more than
one button is pressed simultaneously, the resulting operation is not guaranteed.
● The screen becomes blank when the backlight is burnt out; however, the touch panel
remains enabled. Incorrect touch panel operation will occur when operating the touch
panel when the backlight appears to be turned off but is actually burnt out. Note that this
erroneous operation may result in damage.
● Do not push hard or scratch the touch panel and protection sheet with a hard object
such as a tool, because they are damaged easily.
● At temperatures over the rated operating temperature, the clock accuracy is affected.
Adjust the clock before use.
● For applications which require clock accuracy, adjust the clock periodically.
● Do not install the Touch in areas subjected to strong ultraviolet rays, since ultraviolet
rays may impair the quality of the LCD.
● Do not attempt to disassemble, repair or modify the Touch. This can create the risk of
fire or electrocution.
● When disposing of the Touch, do so as an industrial waste.
● Do not switch off the power or pull out the USB Flash Drive while it is being accessed, as
this may result in destruction of the stored data. If the data on the USB Flash Drive is
corrupted, format the USB Flash Drive.