Instruction Manual
27
7.3 Installation
• Make a panel cut-out on the panel with the dimensions shown below.
• The Touch has the mounting clip positions not only on the top and bottom side (0.3 to
0 35 N
·
m).
● Do n
ot tighten excessively, otherwise the Touch may warp and cause wrinkle on the
display, or impair the waterproof characteristics.
● If the mounting clips are tightened obliquely to the panel, the Touch may fall off the
panel.
● When installing the Touch into a panel cut-out, make sure that the gasket is not twisted.
Especially when re-installing, take special care because any twists in the gasket will
impair the waterproof characteristics.
● Even in the panel thickness range, there is a risk that the waterproof characteristics
cannot be maintained due to the panel materials and size.
Unit: mm
A B Panel Cut-out
66.0
+1.0
0
105 0
+1.0
0
1.0 to 5 0
$
#
TOP
BOTTOM
Mounting Clip Position