Datasheet
For more information, visit http://asia.idec.com
E-081
APEM
Switches &
Pilot Lights
Control Boxes
Emergency
Stop Switches
Enabling
Switches
Safety Products
Explosion Proof
Terminal Blocks
Relays & Sockets
Circuit
Protectors
Power Supplies
LED Illumination
Controllers
Operator
Interfaces
Sensors
AUTO-ID
Safety Products
Interlock
Switches
Non-contact
Interlock Switches
Safety Laser
Scanners
Safety Light
Curtains
Safety Modules
HS6B
HS6E
HS5D
HS5L
HS1L
Actuators for
HS1/HS5/HS6
Actuators/
Padlock Hasp
HS5 Series Slide Handle Actuator
Dimensions
Panel Cut-out
Mounting
Centers: X
Rear Unlocking Button Hole (Note 1)
4-M6
15
8064
ø22
225
111
12
42
Rear Lever Hole
123 (Note 2)
Material:
PA6 (black)
Material:
PA6 (black)
Material:
PA6 (black)
Material: PA6 (black)
Material: ST37
zinc coated
Material:
ST37
zinc coated
Material: ST37
zinc coated
Material: ST37
zinc coated
Material: ST37
zinc coated
M6 screws
(Note 3)
M6 screws
(Note 3)
M6 screws (Note 3)
Material: stainless steel
4-M4 screws
Material:
PA66 (red)
Rear Unlocking
Button Link ø10.4
(20)
61*
55*
136
Mounting
Part
Thickness
: Y
One-side screw (M5)
(15)
UNLOCK
LOCK
8
97
30
10
225
245
11035
14
33
106
69
33
27
8
59
60
42
20
20
22
WW
Mounting part width: W
(Note 3)
In the example shown on the left, a 40mm frame
is used.
Note 1: Mounting holes must be provided when using
HS5E/HS5E-K/HS5L.
When using HS5D, rear unlocking button
is not required and mounting holes are not
required. Mounting part (frame) of up to
70mm thick can be used.
Note 2: Ensure that rear lever does not interfere with
the frame.
Note 3: When choosing mounting part (frame), note
that the mounting screws are M6 (must be
purchased separately).
All dimensions in mm.
Legend Item
HS9Z-EH5L Slide Handle Actuator
Manual Rear Unlocking Button Kit for Frame
(HS9Z-FL5, sold separately) (See the table below)
HS5E Interlock Switch with Rear Unlocking Button
(HS5E-44L
**
-G, sold separately)
Part No. Mounting Part Thickness: Y
HS9Z-FL54 30 ≤ Y ≤ 35
HS9Z-FL55 35 < Y ≤ 45
•Contact IDEC for mounting part thicker than specied above.
Applicable frame size (hinged door)
Frame Size W Mounting Centers X
40 ≤ W ≤ 45 55 ≤ X ≤ 60
45 ≤ W ≤ 50 55 ≤ X ≤ 65
50 ≤ W ≤ 55 60 ≤ X ≤ 70
55 ≤ W ≤ 60 65 ≤ X ≤ 70
•Make sure to observe the applicable frame size,
otherwise the actuator cannot be inserted/removed
properly.
For more information, visit http://eu.idec.com