Datasheet

Download catalogs and CAD from http://asia.idec.com/downloads
E-090
APEM
Switches &
Pilot Lights
Control Boxes
Emergency
Stop Switches
Enabling
Switches
Safety Products
Explosion Proof
Terminal Blocks
Relays & Sockets
Circuit
Protectors
Power Supplies
LED Illumination
Controllers
Operator
Interfaces
Sensors
AUTO-ID
Safety Products
Interlock
Switches
Non-contact
Interlock Switches
Safety Laser
Scanners
Safety Light
Curtains
Safety Modules
HS6B
HS6E
HS5D
HS5L
HS1L
Actuators for
HS1/HS5/HS6
Actuators/
Padlock Hasp
HS5 Series Padlock Hasp
• When using the HS9Z-PH5 for safety-related equipment in a con trol
system, refer to the safety standards and regulations in each country
to make sure of correct operation. Also, perform a risk assessment to
ensure safety before starting operation.
• Read the instruction sheet of the interlock switch to be used.
• Note the projections on the HS9Z-PH5 when using to prevent injury.
• Insert the HS9Z-PH5 in the direction as shown in the following g ure.
Do not insert from any other direction. Also, do not use the slot plug
supplied with the interlock switch.
Actuator Entry Slot
Interlock Switch
HS9Z-PH5
• Do not deform the HS9Z-PH5. The HS9Z-PH5 may come off from the
interlock switch even if a padlock is installed. Stop using imme diately
if the HS9Z-PH5 becomes deformed.
• The shackle diameter of the applicable padlock (refer to the follow ing
gure) is ø5.5 to 7.5 mm.
Shackle Diameter
• When using a hasp or special padlock, make sure that the sliding tab
does not slide 3 mm or more in the direction shown below, oth erwise
the HS9Z-PH5 may come off the interlock switch.
3 mm
3 mm
Sliding Tab
Cover
Round Holes
Oblong Hole
• When using a hasp such as shown below, make sure that the hasp is
installed in round holes not in the oblong hole. Otherwise the sliding
tab may slide 3 mm or more. Check periodically that the narrow gap
between the jaws is not widened, so that the HS9Z-PH5 does not fall
off from the hasp.
Narrow Gap
• Keep the weight of padlocks and hasps to a maximum of 1500g on
one tab hole, and at a maximum of 3000g for the total of all tab holes.
Using padlocks and hasps weighing over the maximum allowable
weight may cause deformation of the HS9Z-PH5, and the interlock
switch may be damaged.
• Do not apply excessive shock to the HS9Z-PH5 while installing it on
the interlock switch, otherwise failure or damage may be caused.
• Do not apply excessive vibration while padlocks or hasps are
installed, otherwise failure or damage may be caused.
• The HS9Z-PH5 is used for HS5D/HS5E/HS5E-K/HS5L interlock
switches. Do not use the HS9Z-PH5 for any other products.
• Make sure that locking and unlocking the padlock and hasp do not
interfere with other products in close proximity.
• Do not modify or disassemble the HS9Z-PH5.
• Padlocks and hasps are available from the following manufactur ers.
Panduit Corporation (http://www.panduit.com/)
Master Lock Company (http://www.masterlock.com/)
Precautions for Installation
SEUEN01A_E Actuators June 2020
Download catalogs and CAD from http://eu.idec.com/downloads