Datasheet

64
Replacing the LED Unit
The LED unit can be replaced without tools by pulling out the
lens unit from the contact block.
LED UnitContact Block
Orientation of the LED unit
Insert the LED unit into the contact block with the TOP
markings on the contact block and LED unit in the same
orientation.
TOP
TOP
Notes on replacing the LED Unit
When replacing the LED unit, make sure that static
electricity is not applied.
Make sure that the LB/LBW series has cooled down before
replacing the LED unit. To avoid burn injuries, be careful not
to touch the unit while it is still hot.
Notes on Using Quick Connect Terminals
1) Use #110 tab quick connects, 0.5 mm-thick.
2) When connecting the terminals on the left and center,
make sure that surfaces of the quick connects face each
other. Otherwise, short-circuit may occur.
TOPTOP
Correct Incorrect
3) Apply only horizontal force against the panel to the tab.
The switch may be damaged if a force other than a
horizontal force is applied.
Instructions
LB/LBW Series Instructions
LBW Series
Lens Round Flush Square Round Extended
Built-in Marking Plate
Engraving
Area
Anti-
rotation
edge
16.4
ø17
1.1
0.85
ø16.8
Engraving
Area
0.85
16.4
18.4
14.0
5.15 0.85
14.0
ø15.8
ø15.8
Engraving
Area
Anti-
rotation
edge
ø14
• Engraving thickness: 0.5 mm max.
• The marking plate is made of white acrylic resin.
Applicable Marking Film
16.4
ø18.4
18.4
14.0
5.15 0.85
14.0
ø15.8
ø15.8
Engraving
Area
Anti-
rotation
edge
ø14
• Film thickness: 0.1 mm per 2 films or 0.2 mm per film.
• Marking film is not included.
• Recommended marking film: Polyester film
LBW Series (ring-illuminated model)
Lens Round (Note) Square
Applicable
Marking Film
ø16 max.
18.4
• Film thickness: 0.1 mm max.
Note: Use a film with adhesive and attach on the light shield
sheet. Make sure that the marking film is properly installed
and does not protrude from the edge of light shield sheet.
Ring Illuminated Model Lens Holder
Light shield
sheet
Insertion Order of Marking Plate and Film
Color Lens
Color Lens
Film
Film
Lens Holder
Lens Holder
LB/LBW Series Round
LB/LBW Series Square/Rectangular
Marking Plate
Marking Plate
Engraged
Area
Engraged
Area
Note: Film is not included.
The marking plate must be engraved on the specified side
as shown above. Pay attention to the orientation of the
marking plate. When inserting a film, make sure to insert
between the color lens and marking plate.
Note: Marking plate is not supplied with ring-illuminated
model.