Operation Manual

To a Handset
Use the following procedure:
If the fault persists …
Disconnect all other instruments connected to the same
line as the
 Disconnect the Base unit from the telephone line and
plug a different phone into the master telephone socket.
Try making a call. If this works, the line is OK.
 If the call does not work, and you are using a two-way
socket adapter, remove it and plug a telephone directly
into the socket. If the call now works, the adapter may be
faulty.
If you cannot make a call, the fault may be on the
line. Contact the service provider (the your cabe
company).
If you still cannot identify the cause of the problem,
contact the Help Line on 888 453 7440
Toll free from the US and Canada.
Troubleshooting continue...
“How to de-register a
Handset from the Base
unit.”
1
2
3
4
5
6
WARNING: You should not use this function unless
the Handset has lost registration.
iDECT X2i and check if you can make a call.
Press button
soft
Ö
display shows highlighted
Menu
HANDSET
Press DOWN button
until
option is highlighted.
BASE
Press button
soft
Ö
display shows
Select
DIAL MODE
Press DOWN button
until
option is highlighted.
DE-REG HS
Press button to confirm
soft
Ö
display shows
Select
CONFIRM?
Press button to confirm
soft
OK
de register
38
exchange
You need to replace the batteries. Please note the
following safety warnings:
 Use only rechargeable batteries in the Handset. The
best way to make sure you get the right ones is to take
the old ones with you when you go to buy new ones.
 Dispose of used batteries safely - never burn them, or
put them where they could get punctured.
“I try to recharge
the batteries, but
I still get a warning
that they are low.”