Operation Manual

- 5 - 090513

Cleaning and Maintenance

Pay attention to the safety precautions, including those in the installation instructions!

• To clean the lamp, use only a soft, antistatic and lint-free cloth. Do not use solvents or abrasives!

Bulb Replacement

Pay attention to the safety precautions, including those in the installation instructions!

ATTENTION! Bulbs are very hot when switched on. In order to prevent burns please let the bulbs cool down

for about 10 minutes before replacement.

• 1. Turn off the power supply.

• 2. Remove the bulb from the lamp holder by pulling and slight tilting.

• 3. Observe the technical data when choosing a replacement bulb.

• 4. Carefully push the new bulb into the lamp holder.

• 5. Turn on the power supply.

• Bulbs are consumable parts subject to wear and tear and therefore not covered by warranty (guarantee)!

Disposal

Dispose of the lamp and old bulbs according to the relevant legal requirements.

Technical Data

• Model name: KL-G904

• Supply Voltage: 230 V~, 50 Hz

• Maximum wattage: 25 W

• Bulb Type: ZVEI: QT14 230 V G9 25 W

• Wattage per bulb: maximal 25 W

• Primary Cable: 1,80 m including cable switch and EURO plug

• Clamp thickness: 15 mm to 25 mm

Content

1 x Instruction Manual

1 x Pre-assembled Luminaire

1 x Lamp holder key

1 x Bulb QT14 230 V G9 25 W

Mounting and Assembly Instruction

for

Clip Lamp

KL-G904

j k

Do not dispose of used devices as domestic

waste. Return to authorised collection point.

Imported by: Dirk Rossmann GmbH

PAGE 1
Cleaning and Maintenance Pay attention to the safety precautions, including those in the installation instructions! • To clean the lamp, use only a soft, antistatic and lint-free cloth. Do not use solvents or abrasives! Bulb Replacement Pay attention to the safety precautions, including those in the installation instructions! ATTENTION! Bulbs are very hot when switched on. In order to prevent burns please let the bulbs cool down for about 10 minutes before replacement. • 1. Turn off the power supply. • 2.
PAGE 2
Cut the power supply completely and provide a safeguard to prevent reconnection in case of damages of any kind, particularly in wet conditions when a safe operation is no longer ensured. Only qualified persons may conduct repairs, original spare parts are required. ATTENTION! Read Carefully! Before you install this luminaire, read this instruction manual carefully! Mounting Assembly Introduction Dear Valued Customer, We thank you for the purchase of this quality product.