User Manual

MorphoAccess® Sigma Series - Installation Guide

Section 1 :Introduction

MORPHO DOCUMENT – REPRODUCTION AND DISCLOSURE FORBIDDEN

SSE-00000XXXXX-01

September 2013

Recommendations for terminal implementation

Every installation is unique. Sometimes the issues are well defined and can be

handled in a standard fashion; sometimes the issues are very specific and may not be

immediately recognizable.

Morpho recommends following these steps for a successful installation:

 Plan the installation - Choose the type of hardware required, decide if a network is

required, and decide on the location and number of required devices.

 Unpack all items - Unpack all items and check against the packing list.

 Install network hardware components - Install the cabling and components

needed to run the system.

 Install software - Install the software needed to set up the devices.

 Pre-configure device - Connect the device to the Ethernet, supply power to the

device, and pre-configure the device.

 Mount devices - Mount the devices in their final locations

 Power distribution and device hook up - Connect the device wiring via the back

panel.

 Power-up procedure - Check the power connections, verify if battery is attached

and then start the system safely. First Boot Assistant screen is displayed, where

you can perform fundamental configuration.