User Manual

MorphoAccess® Sigma Series - Installation Guide

Section 3 :

Installation Procedure

MORPHO DOCUMENT – REPRODUCTION AND DISCLOSURE FORBIDDEN

SSE-00000XXXXX-01

September 2013

Before proceeding to the installation

 Make sure that you have all the components described in “Components of the

initial package” section at your disposal.

 Remove the wall plate. Keep this element at hand.

 Remove the screw at the bottom of the product. Keep this element at hand.

Figure 6: Removing wall frame and screw

It is then possible to fix the terminal on the wall.

The recommended height for fixing of the terminal is 1.40m (camera height).

For an optimal use the terminal must be installed in an area where the lighting

conditions are controlled. Avoid direct exposure of the sensor to the sun light and

ensure good ambient lighting for face detection if used.