User Manual

MorphoAccess® Sigma Series – Installation Guide
Section 3 :
Installation Procedure
SSE-00000XXXXX-01
MORPHO DOCUMENT – REPRODUCTION AND DISCLOSURE FORBIDDEN
27
September 2013
Installation
Required tools (not supplied)
 Four (4) raw plugs + four (4) ø 3.5mm max and length 30mm screws.
 One (1) screwdriver adapted to screws above.
 One (1) Drill (with a drill bit diameter adapted to raw plugs above).
 One (1) hole saw ø 67mm (depending on installation case).
 One (1) Flat tip screwdriver (0.4x2.0) for block connector cable removal.
 A (1) Torx T10 screwdriver
 Deadbolt/door strike
 Snubber diode required to protect regulated DC power supply from inductive
kickback (1N4007 diode or equivalent recommended)
 Separate power supply for the deadbolt/door strike based on supplier's
recommendations.
 External relay (if required)
 Networking cable
Equipment from the initial package to use
 One (1) MA Sigma terminal
 One (1) wall plate.