User Manual

MorphoAccess® Sigma Series - Installation Guide
Section 3 :
Installation Procedure
28
MORPHO DOCUMENT – REPRODUCTION AND DISCLOSURE FORBIDDEN
SSE-00000XXXXX-01
September 2013
Step by step procedure
Figure 7: Face camera viewing angle
The recommended height for fixing of the terminal is 1.40m (camera height).
For an optimal use the terminal must be installed in an area where the lighting
conditions are controlled. Avoid direct exposure of the sensor to the sun light and
ensure good ambient lighting for face detection if used.
Power supply from electrical source shall be switched off before starting the
installation.
The strength of the attachment depends on the solidity of the wall on which the
terminal is mounted.
To ensure water tightness, the wall plate has to be sealed with a silicone bead (refer
to corresponding picture for process).