User Manual

MorphoAccess® Sigma Series – Installation Guide
Section 4 :
Electrical Interface
SSE-00000XXXXX-01
MORPHO DOCUMENT – REPRODUCTION AND DISCLOSURE FORBIDDEN
43
September 2013
Ethernet connection
Ethernet interface can be used to power the MorphoAccess® Sigma Series terminal
through POE (Power Over Ethernet) mode. According to the POE standard two modes
are available: power on data pins and power on dedicated pins.
Use either one of these modes depending on POE implementation on your local
Ethernet network.
Wifi or 3G dongle cannot be used with POE power supply
Ethernet cable shall be shielded
Default Ethernet configuration
By default, MorphoAccess® Sigma Series terminal is configured in DHCP mode
Recommendations for RJ45 wiring
Pin
1
2
3
4
5
6
7
8
Signals
TX(+)
TX(-)
RX(+)
NC/POE pin
dedicated (+)
NC/POE pin
dedicated (+)
RX(-)
Ground/ pin
dedicated (-)
NC/POE pin
dedicated (-)
EIA / TIA
T568B
Colors
White
orange
Orange
White
green
Blue
White blue
Green
White brown
Brown
EIA / TIA
T568A
Colors
White
green
White
green
White
green
White green
White green
White
green
White green
White green
Corel L120
Colors
Grey
White
Pink
Orange
Yellow
Blue
Purple
Brown
Figure 23: RJ45 wiring
RJ45 plug pinout is compliant with 10/100 base T, IEEE802.3 Specification.