User's Manual

MorphoAccess® SIGMA Extreme Series - Installation Guide
Section 4 : Electrical Interface
Identity & Security
2017_2000024418 - Draft
V0
January 2017
This document and the information therein are the property of Safran Identity & Security.
They must not be copied or communicated to a third party without the prior written authorization of Safran
47
Wi-Fi™ dongle installation
Wi-Fi™ dongle shall be installed inside the product and connected to the internal USB
Mini B (at the rear of the terminal) using Safran Identity & Security cable provided in
the kit.
Product integrating Wi-Fi™ dongle shall not be exposed to temperature exceeding
35°C and shall not be exposed to direct sun.
Wi-Fi™ feature requires the product to be powered from an external DC 12V to 24V
power supply (the POE doesn’t provides enough power for both the terminal and the
Wi-Fi™ dongle).
Only Wi-Fi™ USB dongle delivered by Safran Identity & Security (kit reference
293686787) may be installed with the terminal for WLAN (Wireless Local Area
Network) operation.
Cable has to be plugged on the upward USB connector of the rear panel, as on the
following image:
Figure 25: Wi-Fi™ dongle installation
USB extension
cord
Wi-Fi™ USB
dongle