User's Manual

MorphoAccess® SIGMA Extreme Series - Installation Guide

Identity & Security

Section 5 :User Interface

This document and the information therein are the property of Safran Identity & Security.

They must not be copied or communicated to a third party without the prior written authorization of Safran

2017_2000024418 - Draft

January 2017

MorphoAccess® SIGMA Extreme Series native mode

MorphoAccess® SIGMA Extreme Series terminal is by default in native mode, that is

named MA5G. It will support the new features and configurations only in the native

mode. The terminal can be configured using an internet browser connected to the

embedded Webserver application.

NOTA : When terminal mode is switched from MA5G to Morpho legacy mode, the entire

configuration (excepted communication links) and all databases are erased

NOTA : The terminal is rebooted on mode change and factory settings are applicable.

Once the product is configured in native mode, the following methods can be used to

configure the terminal:

 through the Ethernet interface (remote management)

 through a Wi-Fi™ connection (license and dongle required)

Configuration procedures are described inside the MorphoAccess® SIGMA Extreme

Series Administration Guide as follows:

 Section 4: Terminal Configuration And Administration