Installation Guide

MorphoAccess® VP MD – Installation Guide
Section 1 :Introduction
2019_200000XXXX-V0
IDEMIA DOCUMENT - REPRODUCTION AND DISCLOSURE PROHIBITED
19
December 2018
To secure properly an access, IDEMIA recommends installing the MorphoAccess® VP
MD terminal as a part of the typical Access Control environment, as the one described
in the figure below.
Figure 1: Implementation Recommandations
This environment comprises:
The MorphoAccess® VP MD terminal itself
Its role is to perform one-to-many multimodal biometric identification or one-to-one
multimodal biometric verification, i.e. to identify the individual who is presenting his
finger on the terminal sensor by comparing his biometric data with the references
previously stored in the terminal database (in the form of multimodal biometric
templates) or to verify his identity using the reference stored in a contactless card
presented to the terminal.
An Access Controller (3rd party product)
The Controller is the element which controls the access rights of the individuals to the
secured area. For that reason, it must be located in the secured area.
ACCESS CONTROL
SYSTEM
(*) OR EQUIVALENT
NON SECURED
AREA
ACCESS
CONTROLLER
TCP/IP, Wiegand, Dataclock, RS485
ELECTRIC
LATCH (*)
SECURED
AREA
Dry Contact
MorphoAccess
®
VP MD Terminal
Dry Contact
ALARM