Installation Guide

MorphoAccess® VP MD – Installation Guide
Section 2 :General Description
2019_200000XXXX-V0
IDEMIA DOCUMENT - REPRODUCTION AND DISCLOSURE PROHIBITED
27
December 2018
Output relay switches
Access granted: 1 switch two outputs (normally “open”
and normally “closed”)
30V DC – 1A max (Resistive/inductive loads)
USB host port
Front port for terminal configuration through a USB
mass storage key or for Wi-Fi™ USB dongle.
Input signals
LED1/LED2 to activate the access granted relay
Power supply
12 to 24 V DC power supply (1A min @12V)
Or by Power Over Ethernet through RJ-45 connector
Security of the terminal
Anti-tamper-pulling switches.
Tamper-pulling detection: one relay switch.
Size and weight
W x H x D: 90 mm x 160 mm x 125 mm
(3.54” x 6,3” x 4,92”)
675g with wall plate
515g without wall plate
Environmental
conditions
Operating temperature -10 °C to + 50 °C (14°F to 122°F)
Operating humidity 10 % < RH < 80 % (non condensing)
Storage temperature -20 °C to + 70 °C (-4°F to 158°F)
Storage humidity 5% < RH < 95 %
IP55 rated for outdoor use (once wall-mounted)
The terminal should be installed in controlled lighting
conditions.
Avoid direct exposure to sunlight or to UV lights.
Certifications
CE, IEC 60950-1, FCC Part 15, RSS210 - Issue 8 : 2010,
RSS-102 - Issue 5 : 2015, RSS-Gen – Issue : 2014, RoHS,
WEEE