Installation Guide

MorphoAccess® VP MD – Installation Guide

Section 3 :Installation Procedure

2019_200000XXXX-V0

IDEMIA DOCUMENT - REPRODUCTION AND DISCLOSURE PROHIBITED

December 2018

Before proceeding to the installation

 Make sure that you have all the components described in “Components of the initial

package” section at your disposal.

 Remove the bottom cover from the terminal (with its gasket), the top cover (see

Figure 6: Removing the top cover for how to unclip it) and the wall plate. Keep these

elements at hand.

Figure 6: Removing the top cover

It is then possible to fix the terminal:

 either directly on a wall,

 or using a standard electric case (not provided).

The recommended height for fixing of the terminal lies between 1m and 1.20m.

For an optimal use the terminal must be installed in an area where the

lighting conditions are controlled. Avoid direct exposure of the sensor to

the sun light and to the ultraviolet rays (UV).





