Installation Guide

MorphoAccess® VP MD – Installation Guide

Section 3 :Installation Procedure

2019_200000XXXX-V0

IDEMIA DOCUMENT - REPRODUCTION AND DISCLOSURE PROHIBITED

December 2018

Figure 8: Wall plate fixing

Fix the wall plate using the two screws that fit the rawplugs (Max diameter: 3.5 mm,

length 30 mm) (see Figure 7: Drilling template and Figure 8: Wall plate fixing). Use the

2 upper screw shanks to make sure that the wall plate is mounted horizontally.

Cabling

Cable for wiring shall be AWG 20 to 24, length shall be adapted to the size of the hole

in the wall, to terminal connections, and to the distance between the electric source

and the terminal itself.

Plug Ethernet cable (if present) into the RJ45 connector (see Figure 5: MorphoAccess®

VP MD terminal rear view).

Terminal body mounting

Fix Terminal’s body with four (4) M3x8 screws (see Figure 9: Terminal’s Body fixation)

Figure 9: Terminal’s Body fixation