Installation Guide

MorphoAccess® VP MD – Installation Guide
Section 3 :Installation Procedure
2019_200000XXXX-V0
IDEMIA DOCUMENT - REPRODUCTION AND DISCLOSURE PROHIBITED
34
December 2018
Closing
Clip the top cover (see Figure 6: Removing the top cover, following steps 1 to 3 in
reverse, and Figure 10: Assembling top and bottom covers).
Screw on the bottom cover (see Figure 10: Assembling top and bottom covers1), using
the four K2.5 x 8 screws.
Power has to be set up just after closing it. If product has to be stored for a long time
(more than 48 hours), don’t forget to restore its configuration before use.
Figure 10: Assembling top and bottom covers