Installation Guide

MorphoAccess® VP MD – Installation Guide

Annex 1 : Finger Placement Recommendations

2019_200000XXXX-V0

IDEMIA DOCUMENT - REPRODUCTION AND DISCLOSURE PROHIBITED

December 2018

Wiring overview

Before proceeding, make sure that the person in charge of installation and

connections is properly connected to earth, in order to prevent

Electrostatic Discharges (ESD).

Power supply ground shall not be used for peripheral ground. All other

grounds can be used indifferently.

Note that all connections of the MorphoAccess® VP MD terminal described hereafter

are of SELV (Safety Electrical Low Voltage) type.

Figure 11: Cabling layout

RJ45

USB

19 Green / Red WIEG_IN_D0

20 White / Red WIEG_IN_D1

21 Green WIEG_OUT_D0

23 White WIEG_OUT_D1

24 Blue WIEG_OUT_LED1

22 Blue / Red WIEG_OUT_LED2

18 Black / Red WIEGAND_GND

15 Blue / Black RS485_RX+/TX+ (A)

13 Blue / White RS485_RX-/TX- (B)

17 Black / Red RS485_GND

1 Red Power +12V

2 Black Power GND

3 Light Blue SWITCH_PIN1

4 Pink SWITCH_PIN2

5 Yellow / White RELAY_NO

6 Grey / White RELAY_COM

7 Orange / White RELAY_NC

9 Orange GPI0

11 Orange / Red GPI1

16 Orange / Black GPI2

10 Yellow GPO0

8 Yellow / Red GPO1

14 Yellow / Black GPO2

12 Black / Red GPIO_GND