Installation Guide

MorphoAccess® VP MD – Installation Guide
Annex 1 : Finger Placement Recommendations
2019_200000XXXX-V0
IDEMIA DOCUMENT - REPRODUCTION AND DISCLOSURE PROHIBITED
50
December 2018
Wi-Fi™ dongle installation
Wi-Fi™ dongle shall be preferably installed outside the product (separate area shall be
reserved in the wall) and connected to the internal USB Mini B (at the rear of the
terminal) using Morpho cable provided in the kit.
Wi-Fi™ dongle shall not be exposed to temperature exceeding 50°C (don’t forget to
count the thermal dissipation of the product and of the Wi-Fi™ dongle).
Wi-Fi™ feature requires the product to be powered from an external DC 12V to 24V
power supply (the POE doesn’t provides enough power for both the terminal and the
Wi-Fi™ dongle)
Only Wi-Fi™ dongle delivered by IDEMIA (kit reference 293686787) may be installed
with the terminal for WLAN (Wireless Local Area Network) operation.
Cable has to be plugged on the upward USB connector of the rear panel, as on the
following image:
Figure 26: Wi-Fi™ dongle installation
Wi-Fi™
USB
dongle
USB
extension
cord