Installation Guide

VisionPass - 2019_2000045728

1.7 > Recommendations for terminal implementation

Every installation is unique. Sometimes the issues are well defined and can be handled in a standard

fashion; sometimes the issues are very specific and may not be immediately recognizable.

Idemia recommends following these steps for a successful installation:

Plan the installation - Choose the type of hardware required, decide if a network is required, and

decide on the location and number of required terminals.

Unpack all items - Unpack all items and check against the packing list.

Install network hardware components - Install the cabling and components needed to run the

system.

Install software - Install the software needed to set up the terminals.

Pre-configure device - Connect the terminals to the Ethernet, supply power to the terminals, and pre-

configure the terminals.

Mount devices - Mount the terminals in their final locations

Power distribution and device hook up - Connect the terminals wiring via the back panel.

Power-up procedure - Check the power connections, and then start the system safely. First Boot

Assistant screen is displayed, where you can perform fundamental configuration.