Installation Guide

67
VisionPass - 2019_2000045728
Global warning
The manufacturer cannot be held responsible in case of non-compliance with the following
recommendations or incorrect use of the terminal.
General precautions
Do not attempt to repair your terminal yourself. The manufacturer cannot be held responsible for any
damage/accident that may result from attempts to repair components. Any work carried out by non-
authorized personnel will invalidate your warranty.
Do not expose your terminal to extreme temperatures.
Use your terminal with original accessories. Attempts to integrate unapproved accessories to the
terminal will void your warranty.
Due to electrostatic discharge, and depending on the environment, synthetic carpet should be avoided
in areas where the terminal has been installed.
Do not tilt the product.
Do not use blunt force on the product.
Do not attach anything to the product.
Do not place anything on the product.
Switch off the device before unplugging it.
Biometric performance
Do not scratch the product, particularly on the glass, because the performance of the product depends
of the state of the glass surface and its anti-reflective face.
Clean the glass every day to optimize performance of the product.
Avoid direct sun light on the product.
Areas containing combustibles
It is strongly recommended that you do not install your terminal in the vicinity of gas stations, petroleum
processing facilities or any other facility containing flammable or combustible gasses or materials.
Specific precautions for terminals equipped with a contactless smartcard reader
It is recommended to install terminals equipped with a contactless smartcard reader at a certain
distance (> 30cm) from metallic elements such as iron fixations or lift gates or radio product (such as
contactless smartcard reader). Performances in terms of contactless badge reading distance will
decrease when metallic elements are closer.
Ethernet connection
It is recommended to use a category 5 shielding cable (120 Ohms). It is also strongly recommended
to insert a repeater unit every 90m.
Extreme care must be taken while connecting Ethernet wire to the terminal block board since low
quality connection may strongly impact Ethernet signal sensibility.
It is recommended to connect Rx+ and Rx- with the same twisted-pair wire (and to do the same with
Tx+/Tx- and the other twisted-pair wire).
Date / Time synchronization
The terminal clock has a +/-10 ppm typical time deviation at +25°C (roughly around +/- 6 sec per 48
hours). At lower and higher temperature (but within normal operating temperatures), deviation may be
more important (worst case: - 14 seconds per 48 hours).