User's Manual

Radio Frequency (RF) Exposure Compliance of Radiocommunication
portable apparatus
This device complies with FCC and ISED Canada RF radiation exposure limits set forth for general population
(uncontrolled exposure). This device must not be collocated or operating in conjunction with any other antenna or
transmitter.
Conformité à l’exposition aux champs RF des équipements radio portables
Cet appareil est conforme aux limites FCC et ISDE Canada concernant l'exposition aux rayonnements RF établies
pour le grand public. (Environnement non-contrôlé)
Cet émetteur ne doit pas être co-situé ou fonctionner conjointement avec une autre antenne ou un autre émetteur.
ATEX Certification
Equipment or protected system intended for use in potentially explosive atmosphere directive 2014/53/EU.
Compliance with the essential health and safety Requirements has been assured by compliance with the following
standards:
EN 60079-0, EN 60079-11
IECEx Certification
The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the
identified documents, was found to comply with the following standards:
IEC 60079-0:2017, IEC 60079-11:2011
Special conditions for safe use – ATEX and IECEx
WARNING – Maintenance is not permitted. Do not open the housing.
WARNING – Electrostatic Hazard: Clean only with a damp cloth.
WARNING - Electrostatic Hazard: Do not install in locations with increased electrostatic
charge such as close to ventilations systems or electric drives.
WARNING - This product should be installed by personnel trained in installation of equipment
in Hazardous Locations and meet the representative country’s National Electrical Code.
WARNING - Not to be connected to equipment that uses or generates more than 250V with
respect to earth ground
EPS 20 ATEX 1 028 iQ355 XP
II 1G Ex ia IIC T4 Ga
-40°C ≤ Ta ≤ +70°C
Gas
I M1 Ex ia Ma
-40°C ≤ Ta ≤ +70°C
Mining
IECEx EPS_20.0012_000 iQ355 XP
Type of Protection Ex i
Marking Ex ia IIC T4 Ga Gas
Ex ia Ma Mining