User's Manual

iPOINT X – Hardware User Manual | 18.06.2020

3. Initial Operation / Configuration

The configuration of the iPOINT X is managed via the host software.

Available Identec Solutions Software

 Setup Scout

 i-Share

 Crew Companion

Please refer to the relevant software User Manuals for details.

3.1 Status LEDs

UHF

This is the UHF Communication LED. LED blinks green when a

valid command has been sent to Tag. It blinks Orange when a

response or a broadcast is received.

This is the LF Communication LED. LED blinks green when

Marker Loop ID is sent. It blinks red if LF is not working properly

(e.g. loop broken or loop current too low).

COM

This is the wired interface LED. It blinks green when a command

is received and orange when responding over RS422 or RS485.

Note: Because of short communication you can see just the

orange blink.

RUN

This is the general Device run LED. It blinks Green if everything

is OK. Blinks red if the voltage is too low or a Hardware issue is

detected

NFC (top)

This is the NFC Card read LED. Is green when access is granted,

red when access is denied.