User Manual

_________________________________________________________________________
Document #7201-002, Rev C Page 24
3.3 Boot Menu (Serial)
It is possible to change basic settings such as IP address, passwords, etc. via the serial
interface. To accomplish this, the i-PORT has to be connected via the serial interface to a PC,
(with a null-modem serial cable). Next, you need to start a terminal program (Hyperterminal,
GanTerm, etc.) with the following settings:
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Protocol: None
Start up the i-PORT as soon as there is a connection. Boot information appears on the screen
and you must press the ESCAPE key within 2 seconds to change the standard settings.