User Manual

_________________________________________________________________________
Document #7201-002, Rev C Page 25
You now have the ability to change various standard settings:
Project and Location Info: Location Assignment of i-PORT, Mounting Location
Project Assignment of i-PORT, Project
Password Settings: Password Enable/Disable Password on/off
Username and Password Username/Password
Network Interface Parameters: DHCP/IP Address DHCP or fixed IP
Subnet Mask Subnet mask
Gateway Gateway, if needed
Com1 PPP IP Necessary for GSM-Modem
Com1 PPP Peer IP Necessary for GSM-Modem
Hardware Parameters: Baud Rate Data transmission 1.2 to 57.6 kbit/s
Boot Delay Time to display Boot menu
After the changes have been made and confirmed, the i-PORT will boot up and go into the
designated mode. You can write down the new IP address in the designated spot inside the
i-PORT door.