User Manual

_________________________________________________________________________
Document #7201-002, Rev C Page 8
Mounting the i-PORT
Use the four mounting holes (diameter 5 mm) to attach the i-PORT. The amount of space
required to mount the i-PORT is 200mm x 250mm x 60mm (L x H x W). The i-PORT has a
mass of approximately 2 kg. A 3mm hex wrench is required to open the i-PORT access
door.
Use the rubber grommet with hole to feed cables through the housing to the outside (cable
diameter 4.75 mm to 6 mm); seal the unused feed-throughs with the blind plugs. These
feed-throughs are intended for RG58 (antenna), Ethernet or serial cables. Enclosure
rating IP64 is thus achieved. If a higher enclosure rating is required, the i-PORT must be
placed in an additional housing.