User Manual

i-CARD III User’s Guide
_____________________________________________________________________________________
Document #: 9000-041, Rev C - 9 –
2.2.2 Windows NT
To perform the following steps, administrator rights are required because you
will need to modify your machine’s registry.
Step 1. On the ILR installation disk, go to the \drivers\WindowsNT folder, and
double click on the icard III.reg. The following dialogue box appears:
Click OK
Step 2. Copy the icard.sys file from \drivers\WindowsNT folder to the
\Winnt\system32\Drivers folder on the computer operating the i-CARD.
Step 3. Remove the floppy disk and reboot the computer.
The following screen appears during startup:
Select the Startup Type of the i-CARD device. The Startup Type will vary
from user to user depending on the type of PCMCIA software installed. By
default, Windows NT does not support plug and play devices, therefore the
Startup Type should be set to Automatic. If you have additional software that
permits plug and play devices, then the Startup Type should be set to Manual.
If the above screen does not appear, go to Control PanelÆDevices and select
the Icard device, click Startup, then click Close.
The hardware driver installation is now complete.