User Manual

_________________________________________________________________________
Document #7201-001, Rev C Page 13
Mounting the i-PORT
211
238,7
21,9
180
20,590
5
201
a
Use the four mounting holes (diameter 5 mm) to attach the i-PORT to the side of the
housing. The amount of space required to mount the i-PORT is 200mm x 250mm x 60mm
(L x H x W). The i-PORT has a mass of approximately 2 kg. A 3mm hex wrench is required
to open the i-PORT.
Use the rubber grommet with hole to feed cables through the housing to the outside (cable
diameter 4.75 mm to 6 mm); seal the unused feed-throughs with the blind plugs. These
feed-throughs are intended for RG58 (antenna), Ethernet or serial cables.
Enclosure rating IP64 is thus achieved. If a higher enclosure rating is required, the i-PORT
must be placed in an additional housing.