User Manual

_________________________________________________________________________
Document #7201-001, Rev C Page 30
6.0 Technical Specifications
6.1 Codes, Parameters
ILR
®
Parameters
Compatibility ILR
®
i-Q Tags and
ILR
®
i-D Tags
ILR
®
i-Q Tag ILR
®
i-D Tag
Read range (adjustable) 100m (300 ft) 6m (18 ft)
Write range (adjustable) 100m (300 ft) 6m (18 ft)
Max. response time (single tag) < 150 ms < 10ms
Read rate (ID only) 100 tags/s
Read rate – 128 bit data 35 tags/s
Multi-tag-handling (simultaneous) Up to 2,000 tags
RF Interface
Frequency 868 MHz (EU) or
915 MHz (NA) ISM Band
Certification
RF rate of transmission
FCC, Part 15 (US)
Industry Canada
EN 330 220 (EU)
i-Q 115.2 kbit/s; i-D 38.4 kbit/s (Tx), 115.2 kbit/s (Rx)
Number of antennas 5 (4 read/write + 1 wakeup)
Antenna transmitters 1
Output power: up to 23 dBm — adjustable (50 steps)
Antenna receivers 4
Sensitivity: up to -85 dBm — adjustable (100 steps)
Antenna control Independent antennas, simultaneous operation (receive)
User Interface
Ethernet interface 10 Mbit/s / 100 Mbit/s
Protocols
Ports
TCP/IP, FTP, Telnet, HTTP, SNMP
7090 Debug port, 7070 Communication port
Serial interface RS232 – Setup and diagnostics only
Input control 4 digital inputs for process synchronization
Active when grounded, R
max=560 Ohm
Output control 4 relay outputs for process control
max. breaking capacity: 30W (DC); 62.5VA (AC)
max. contact load: 1A at 30VDC, 0.5A at 125VAC
Status signals 19 status LEDs (for service and installation)
CPU
Operating system RTOS (Real Time Operating System) Thread X
Program memory 2 MB Flash
8 MB DRAM
Data memory 128 KB SRAM
Configuration memory 8 KB EEPROM
Time base Battery-backed Real Time Clock (RTC)
Electrical Data
Input voltage 10 – 30 VDC