User's Manual

i-PORT 350/250 USB - BT
USER GUIDE
VISIBILITY DELIVERED. PAGE 7 OF 22
accept any responsibility for materials used, work carried out or possible consequences from
unauthorized third party vendors.
Electrostatic Discharge
Semi-conductors of the type MOS or CMOS as well as two-pin types and precision resistance are
sensitive to ESD. All components, printed circuit boards and auxiliary systems should therefore always
be classed as sensitive to electrostatic discharge.
Before opening the cover the unit should be placed onto an ESD-protected surface. As with all work
on modern electronic modules, the use of ESD clamps and ESD mats during work on the unit is
recommended.
· Sufficiently protect all printed circuit boards that were removed from the unit from damage.
· Observe all normal precautions for the use of tools.
· Use ESD-protected packaging material.
Never use measuring units with low impedance for measuring or testing systems with semi-conductor
components. Never use high voltage testing units or dielectric test units to test systems with semi-
conductor components.
If it is necessary to check the isolating properties of the field wiring, the assemblies (electronic units
and sensors) should be disconnected.
Earth the test units.
IDENTEC SOLUTIONS does not accept the return of products where the regulations concerning the
ESD precautions and protective packaging materials were not followed.
ESD – Electrostatic Discharge
EMC – Electromagnetic Compatibility
SELV – Safety Extra Low Voltage – Protective measure against dangerous body currents, formerly: protective first voltage range
2. PREFACE
2.1. PREPARATIONS
This installation manual must be read carefully prior to starting the installation. The described
installation works assume that installation materials like cable, antenna and data sensor holder, etc.
are available.