User's Manual

PAC21x1 Installation Manual
IDT.QM.P
2
.T1.DT
REV1.0
Page
6
of
8
Printed copies of this document are uncontrolled Internal Use Only
4.4 Wiring Information
Pig Tail Cable Color
Function
RED + VDC
Black GND
Green Wiegand output D0
White Wiegand output D1
Orange Wiegand Green LED Input
Yellow Wiegand Buzz Input
Blue Input2
Brown Input1
Grey RS485 -
Pink RS485 +
Violet Tamper Output
Black Shrink Tube Drain Wire
Caution:
During Wiring make sure that the +VDC lines does not make contact with any other cables, as it might
affect reader functionality/ cause damage to the reader.
4.5 Mounting the Reader
a. Make two holes on the wall at a vertical distance 80 mm apart to match with the mounting
holes on the Bottom casing.
b. Insert the nylon screw plugs into the wall.
c. Connect the wires on the pigtail cable to the corresponding wires in the cable from the wall.
d. The Bottom casing which is potted is to be now secured onto the wall using the screws
supplied. Once the bottom unit is secured onto the wall, the top casing can be inserted onto
the bottom casing. Ensure that the LED opening on the top casing is aligned with the LED in
the bottom casing.
e. Secure the Top and bottom casing by the #3x8 screw at the slot on the lower side of Top
casing.