User's Manual

PAC21x1 Installation Manual
IDT.QM.P
2
.T1.DT
REV1.0
Page
7
of
8
Printed copies of this document are uncontrolled Internal Use Only
4.6 Power up ad Testing
a. Power Up the reader by connecting the DC power supply at the other end of the cable.
b. The reader beeps long once and blinks red for approximately 30 secs.
c. After this the LED glows RED .
d. Now the reader is in the functional mode.
e. Flash a contactless card on the reader top surface
. The LED will blink Green and then turn
back to Red, to indicate that the card is detected**.
f. The buzzer will make a short Beep to indicate that the card is detected**.
** This behavior is the default reader behavior. This may vary depending on the feedback
available from the control panel on LED (orange wire) and Buzzer Input Lines (Yellow wire).
5. Certifications
5.1 CE Marking
Identive hereby declares that the PAC21X1 devices mentioned herein are in compliance with
the essential requirements and other relevant portions of the Directive R&TTE 1999/5/EC.
5.2 FCC Marking
Labeling requirements
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Information to user
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
FCC ID – MBPPAC21X1-001