User's Manual

Photographs of the Reader
Front view Rear view
Access Granted/Denied
Indication LED
Contactless LED
10 pin terminal block for
Wiegand/Magstripe
8 pin terminal block for
RS485
Contactless field
RS485 DIP switch
Testing
• Connect the reader to the host through Wiegand/Magstripe/RS485 interface.
• Switch on the power to the reader and check if the contactless LED glows. This signifies that the
reader is ready.
• Wave the test contactless card in front of the reader. Check for the contact less LED to blink steadily.
This activity of the reader signifies that the reader is reading the data from the card and passing it to
the host.
• For a successful read, the access control LED bar should glow in GREEN and a short beep must be
heard from the reader.
End of the document
PAT 1111 Installation Manual Page 6 of 6