User's Manual

1.0 Product Specification
1.1 Overview
The term PAT is an acronym for Physical Access Terminal .The PAT readers are designed and constructed to
provide a wide variety of configuration options. The readers support contact, contact less and pinpad
interface. The PAT 11x1 readers are based on ARM7 processor. The contactless interface is controlled by
Mifare IC controller. The readers are designed to support the following communication protocols to interface
with host PC/control panel.
 Wiegand/Magnetic stripe
 RS 485
Two separate slots reside at the back of the readers for the compatibility of the above mentioned
communication protocols. The LED and Buzzer in the readers constantly keep showing the user the status of
the readers during the operation. The PAT11x1 readers are designed for indoor use only.
1.2 Specification
Host Interface
• Wiegand/Magstripe (CLK/Data)
• RS485 (2 or 4 wires)
• 3 relay inputs to set reader state
SAM
• ISO 7816 1-3
• T=0, T=1 protocol support (5V card)
• Communication speed up to 344,086 bps
Smartcard
interface
• ISO 7816 1-3
• T=0, T=1 protocol support (5V card)
• Communication speed up to 115,200 bps
Smartcard
connector
• 8 contacts (ISO location)
• Landing contact, 500,000 insertions
Contactless
• ISO 14443 Type A and B (13.56 MHz)
• Supports ISO 14443 part 1 to 4
• Operating distance: 1 inch for CAC
• Communication speed: 106 Kbps
• Internal 3DES for card authentication (DESFire)
Keypad
• Standard telephone layout (0-9, Clear and Enter)
• Robust hard cap, silicon keypad
Human Interface
• 1 LED beam (green and red) for access information
(granted and denied)
• 1 LED per type of media (contact, contactless and
keypad) to indicate the type of requested operation
• Buzzer for user acoustic feedback
Application
• Full SDK (software development kit) available
• Field Secure firmware upgrade
Dimensions
• LWH 148x84x46 mm
Power
• 12V DC- 200mA
PAT111 OEM Manual Page 3 of 9