User's Manual

PRIMIS
Page 9 of 12
7.4 Mounting the Reader
7.4.1 Reference for location of mounting holes on the wall
7.4.2 Reader Installation Steps
a. Make the required holes on the wall as per the backplate drawing above.
b. The reader is to be mounted at a height less than 2 meters from the floor for MS1 compliance
as per IEC 62368-1
c. Insert the nylon screw plugs into the wall.
d. Connect the wires as per the Table 1
e. Secure the backplate onto the wall using the Screws
f. Hook the reader onto the backplate
g. Secure the reader and backplate by the Screw (SMF #6-32x3/8" SS)