User's Manual
Table Of Contents
- Legal information
- Introduction to the manual
- General information about SDI011
- SDI011 characteristics
- Software modules
- Commands description
- Generic APDU
- Set of APDU for contactless storage user tokens
- Set of APDU for ISO/IEC14443-4 user tokens
- Set of APDU defined by SCM Microsystems
- Escape commands for the contactless interface
- Sending escape commands to SDI011
- Escape command codes
- READER_GETCARDINFO
- READER_LED_CONTROL_BY_FW
- READER_LEDCONTROL
- READER_CNTLESS_GET_MFRC_REV
- READER_CNTLESS_GET_ATS_ATQB
- READER_CNTLESS_GET_TYPE
- READER_CNTLESS_SET_TYPE
- READER_CNTLESS_RF_SWITCH
- READER_CNTLESS_RAW_CFG
- READER_CNTLESS_RAW_XMIT_EX
- READER_ CNTLESS_DISABLE_PPS
- READER_SWITCH_RF_ON_OFF
- READER_CNTLESS_848KBPS
- READER_CNTLESS_BAUDRATE
- READER_CNTLESS_FORCE_BAUDRATE_PCSC_REV2
- Escape commands for the contact interface
- Annexes
SDI011 REFERENCE MANUAL 11
2. Introduction to the manual
2.1. Objective of the manual
This manual provides an overview of the hardware and software features of the SDI011 dual
interface (contactless and contact) reader, hereafter referred to as ―SDI011‖.
This manual describes in details interfaces and supported commands available for developers
using SDI011 in their applications.
2.2. Target audience
This document describes the technical implementation of SDI011.
The manual targets software developers. It assumes knowledge about 13.56 MHz contactless
technologies like ISO/IEC 14443 and commonly used engineering terms.
Should you have questions, you may send them to support@scmmicro.com .
2.3. Product version corresponding to the manual
Item
Version
Hardware
1.0
Firmware
7.36
Windows
Contact Driver
5.19
Windows
Contactless
Driver
5.20
MAC driver
5.0.18
LINUX Driver
5.0.18