User's Manual

uTrust TS Contact Keypad Reader
Page 11 of 15
7.4 Mounting the Reader
7.4.1 Reference for location of mounting holes on the wall
Phoenix connector Reader – 4 Holes and 1 Slot
7.4.2 Reader Installation Steps
a. Make the required holes on the wall as per the backplate drawing above.
b. The reader is to be mounted at a height less than 2 meters from the floor for MS1 compliance
as per IEC 62368-1
c. Insert the nylon screw plugs into the wall.
d. Connect the wires as per the Table 2 or Table 3.
e. Secure the backplate onto the wall using the Screws (A #6-18X1.5" SS )
f. Hook the reader onto the backplate
g. Secure the reader and backplate by the Snake Eye Screw (SMF #6-32X5/16" SS)