User's Manual

Department
MIFCM – User manual
Version 1.00
Internal 8 (8)
Idesco Oy | Teknologiantie 9, FIN-90590 OULU | Tel [phone] | [e-mail] | www.idesco.fi
2.9. Installation
MIFCM must be professionally installed.
The only permitted type of antenna is IA013CM. Use of any other antenna is not permitted.
Due to the unique market and function targeted by this product, this product needs a trained profes-
sional engineer to configure and integrate this product into the final host configuration.
The product will not be sold via retail or directly to the general public or by mail order. It will be sold
to authorized dealers or installers only.
The intended use of this product is not for consumers and general public.
The MIFCM and antenna IA013CM must be assembled in the space which is reserved for them in the
host system. The tag can only be read when it is within the reading distance of the antenna, which is
less than a few centimeters depending on tag type.
The product will be installed inside the host system. It will not be possible to replace either MIFCM or
IA013CM or both later without disassembling the host system first.
This product can be Installed by licensed or authorized professionals.
The installation requires special knowledge of the host system, its functions and operations.
3. FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two condi-
tions: (1) This device may not cause harmful interference, and (2) this device must accept any interfer-
ence received, including interference that may cause undesired operation.
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’In-
novation, Sciences et Développement économique Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est sus-
ceptible d’en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.