User Manual
2 3
• Not intended for critical medical or life support equipment.
• The iDevices
®
Dimmer Switch is not user-serviceable. Do not attempt to open the enclosure for any reason.
• The iDevices
®
Dimmer Switch must be installed in a manner that conforms to all applicable national,
state, and local building codes.
• The iDevices
®
Dimmer Switch is intended for dry, indoor use only.
• Ambient operating conditions: 32º F to 104º F (0º C to 40º C), 0-90% humidity, non-condensing.
• Use with branch circuit breaker 20A or less.
• Notice – Use only copper or copper-clad wire with this device.
• Requires a dimmable bulb.
• For control of permanently installed 150W CFL/LED or 400W incandescent/halogen lamp xtures only.
• Dual Gang Installation: The connected incandescent/halogen load must not exceed 350W for each of the
two iDevices
®
Dimmer Switches.
• Triple Gang Installation: The connected incandescent/halogen load must not exceed 300W for each of the
three iDevices
®
Dimmer Switches.
REQUIRES
• Wi-Fi
®
2.4 GHz 802.11 b/g/n
Compatible Network
• Router Security Settings
Supported: WPA, WPA2, Or None
• Free iDevices
®
Connected App
• 120VAC “Line” (usually black,
blue or red) And “Neutral”
(usually white) Wires In Each
Gang Box
• Controlling this HomeKit-enabled
accessory requires an iPhone,
iPad, or iPod touch with iOS 8.1
or later.
• Android™ 4.3+ Device With
Bluetooth
®
Technology
TOOLS NEEDED
• Philips Screwdriver
• Flathead Screwdriver
• Pliers
• Wire Cutter/Stripper
• Voltage Detector
RATINGS
Input: 120VAC, 60Hz
Output: 120AC, 60Hz
CFL/LED 150W
Incandescent/Halogen: 400W
RISK OF ELECTRIC SHOCK, SEVERE BURNS, AND FIRE: Your safety is important to
us. Electricity is dangerous and can cause personal injury and property damage if handled
improperly. A working knowledge of electrical installation is required to install this product. If
you are not comfortable working with electricity do not attempt to install the iDevices
®
Dimmer
Switch and seek professional assistance from a qualied electrician.
!