User Manual

36 37

STEP 2

Locate the “primary” Switch. Hold “6” until the LED rapidly ashes

blue (5 sec) then release. Next tap “1” to enter pairing mode. The

LED will ash blue slowly.

Next Locate the “secondary” Switch. Repeat the steps above on the

Secondary Switch by holding “6” until the LED rapidly ashes blue

(5 seconds) then release. Next tap “1” to begin the pairing mode.

The LED will ash blue slowly.

The “secondary” Wall Switch will search and pair to the “primary”

switch. The LED on each Wall Switch will rapidly blink green 5 times

and each Wall Switch will beep 5 times to indicate the pairing

process is complete.