Installation Guide

idh
by St. Simons, Inc.
Professional Grade Quality Solid Brass Decorative Hardware & Bath Accessories
Demand Quality, Demand idh©
idhbrass.com
Installation Instructions
Professional Grade Quality Solid Brass
3” x 2” Solid Extruded Brass Loose Pin Mortise Cabinet Hinges (Pair)
Item# 83020
Dimensions:
• Length of Joint: 3”
• Overall Length: 3-3/4”
• Width Open: 2”
• Gauge of Metal: 0.125” (3.175 mm)
• Finial Diameter: 0.32”
• Number of Ways: 5
• Net Weight: 4.0 oz. (1 Hinge)
• Gross Weight: 9.2 oz. (per inner box)
• Solid Brass Wood Screws
Dimensions are for reference use only.
For exact dimensions, please measure actual part.
The instructions below are for reference only. Depending on application, install
may vary. Always consult a professional.
1) Find the desired mounting location for the hinge on the cabinet
face frame. Mark the outline of the hinge leaf with a combination
square.
2) Use a marking gauge to measure the thickness of the hinge leaf
and mark the outer cabinet face to account for the leaf thickness.
3) Use a utility knife to trace out the leaf outline. Finish mortising the
cabinet face frame with either a chisel or wood router.
4) Once mortised, mark the screw holes for the hinge on the cabinet
frame and drill pilot holes. Mount the hinge onto the frame.
5) Mark the leaf outlines, with the combination square, on edge of the
cabinet door. Also mark the face of the cabinet door with the
marking gauge to account for the leaf thickness.
6) Repeat step #3 for the cabinet door.
7) With the leaf at its open position, mark the screw holes for the
hinge on the door and drill pilot holes. Mount the hinge onto the
door.
Catalog Section: J
Item#
83020
Date: Rev 07/20