Manual

12. On the C-6 transmission you

must cut off the original shift

lever on the transmission.

Note: Once you cut the old

shift lever off, there is no

turning back! Remove the

two pan bolts marked with

x’s. Also remove the nut and

washer from the kick down lever and then remove the kick down lever

itself.

13. Spacers need to be placed between the

bracket and transmission pan with the

two bolts supplied in the kit holding it

all together in the holes of the bracket

shown.

14. Make sure that the transmission is in Park. Install the transmission

shift lever using the nut and bolt supplied. Note that it covers the

original shift lever previously cut off. Now install the kick down lever

with the original nut and washer.

15. Take the small nut, two rubber boots, and one large nut and washer

off the transmission end of the cable. Insert the cable into the bracket.

Reinstall the large washer and nut and the two boots. (continued on

next page).