Instruction Manual

11
3.3.2 Install diaper roll
Install the bezel at both ends of the diaper roll and tear off the sticker on the edge of the diaper,
as shown in figure 3 / 21. Stick both ends into the metal bracket for the new diaper coil, and then
pull the diaper roll out to the right into the old diaper bin. The diaper side stickers stick to the
stick, confirm the installation and press the manual stop button once to roll the diaper to the
starting position and start to use it.
3.4 Installation of scenery cloth
The setting cloth is specially designed for male dogs and can be installed as needed. As shown in
figure 3-10, install the two set brackets into the corresponding hole on the platform side of the
camera, and then cover the setting cloth, with the pattern facing the equipment and spreading
the growing part onto the diaper.
Diaper roll stent
Pay attention to the
edge roll-out direction
of the diaper roll.
Two brackets
Stick the diaper edge sticker to the stick
counterclockwise from the bottom up.
Set bracket inserted into platform
mounting hole in this direction