User's Manual

X[
No LCD Display
LED Button
State Description
Left Right Left Right
12
SMART
Mag R/W
On On
Reading or writing the
Magnetic stripe
Magnetic encoder is reading or writing the magnetic stripe
information.
13
Spool Error!
<-Any Key Push ->
Blinking Blinking
Cancel &
Initialize
Cancel &
Initialize
Printingdataisnot
transmitted properly
Shown it when error occurs in a printing data transmission. Press
any keys to delete the spooled data and to return the ready state.
14
Print Error xx
<Replay Cancel>
Blinking Blinking Repeat
Cancel &
Initialize
Error in printing or
moving a card
Error in the printing or the transmission. Retry by pressing the left
button or cancel the command by pressing the right button.
15
Top Cover Open
<-Card Moving ->
Blinking Blinking
Move a
card to the
back side
Moveacard
to the front
side
Top cover open
Top cover is open. The card in the printer can be moved by
pressing the left or right LED button. If press both buttons at the
same time, the print head will be up and down. (Flipper will be flip
over if it is installed)
16
Check Please..
Ribbon Not Found
Blinking Blinking
Ribbon
redetecting
Ribbon
redetecting
There is no ribbon in the
printer or fail to detect
Fail to detect the ribbon. Check the ribbon installed state. If there
is no ribbon, install the ribbon. If there is a ribbon, pull out it and
install again. Press the left or right button to redetect the ribbon.
17
Check Please..
Ribbon Zero
Blinking Blinking
Ribbon
redetecting
Ribbon
redetecting
The installed ribbon has
run out
It is displayed when the installed ribbon is all used up. Replace
with new ribbon. Press the left or right button to redetect the
ribbon.
18
Check Please..
TPH Not Found
Blinking Blinking
Thermal Print head is not
installed
Thermal Print Head is not installed or there is a misconnection of
the cable. Open the top cover to check the print head installed
state or turn off the printer and check the cable connecting state.
19
Print Error xx
Top Cover Open
Blinking Blinking
Fail to move the card out
(Check the card in the
printer)
The card in the printer will be come out when the initialization or
top cover close. If it is not come out, this message will be
displayed. Remove the card and close the top cover.
20
Card Out Error
<Replay Cancel>
Blinking Blinking Repeat
Cancel &
Initialize
Fail to move the card out
(Check the card in the
printer)
After an error occurs in printing, the error card is not come out
even though "Replay" or "Cancel" button is pressed.
21
SMART
Download...
On On Firmware downloading
The printer is downloading the firmware. Do not turn off the power
until it is rebooting. It takes about 20 seconds.
22
Board Test Mode
Wait
Test mode state
Test mode which can test the sensors or motors of the printer.
User can set the LED status.
Table1 Status display