User's Manual

2.2. Loading the cards

This section shows how to l oad the plastic cards.

Pic.19 Adjusting the card thickness lever

2.2.1. Open the input hoppe

cove

2.2.2. Adjust the card thickness with the

card thickness control lever.

(Caution! If the adjustment is not correct, it will

make some error. Use the type of cards in the

specification of this manual. Always keep the

card surface clean state.)

Pic.20 Preparing the card 1

Pic.21 Preparing the card 2

2.2.4. To separate cards from each other,

push a stack of cards back and

forth to an angle about 45 degrees

vertically.

(Static charge makes cards stuck with

significant adhesive force. These cards must be

physically separated from each other before

inserted into the feeder. If not separated,

feeding or printing problems may occur.)